EUTECH INSTRUMENTS ECOSCAN TEMP 456 TEMPERATURE METER Manual de instrucciones descargar pdf (Pagina 5)

1. INTRODUCTION

1.1 Introducing the economy series

Thank you for purchasing the Temp 4/5/6 meter. These microprocessor-based

handheld meters are economical and easy to use. They are available in three

models:

• The Temp 4 uses *YSI 400 series thermistor temperature sensor

• The Temp 5 uses 100K thermistor temperature sensor

• The Temp 6 uses PT100 ohm (Platinum) RTD temperature sensor

All Temp 4/5/6 meter series feature:

• Large LCD for clear and easy reading

• Readings in

C and

F (selectable)

• Minimum and maximum temperature display

• Minimum and maximum hold mode

• Low battery indicator

• Hold function, freezes measured reading

• User calibration - offset adjustment

• Non volatile memory backup; calibration and other information remain if

battery is disconnected

• Temp 5 meter allows user selection of most suitable temperature curve for

its thermistor sensor

This instruction manual is organised for quick reference with step-by-step

procedures that give you thorough review of the various features and meter

operations.

Included with your meter are a temperature sensor (Temp 5 only), rubber boot,

4 alkaline “AAA” batteries, an instruction manual and a warranty card. To order

other accessories, please refer to Section on Accessories for more information.

* YSI is a registered trademark of Yellow Springs Instruments.

1 2 3 4 5 6 7 8 9 10 ... 23 24

Sin comentarios

EUTECH INSTRUMENTS ECOSCAN TEMP 456 TEMPERATURE METER Manual de instrucciones Pagina 5