EUTECH INSTRUMENTS alpha-pH 2000D Manual de instrucciones descargar pdf (Pagina 35)

Instruction Manual αlpha-pH2000D

- 29 -

6.9 Configuration (CNFG) sub-function

In this sub-function you configure the transmitter to suit your requirements.

SETUP

HOLD

SETUP

HOLD

SETUP

HOLD

SETUP

HOLD

SETUP

HOLD

SETUP

HOLD

SETUP

HOLD

ENT

SETUP

HOLD

SETUP

HOLD

SETUP

HOLD

ENT

SETUP

HOLD

SETUP

HOLD

SETUP

HOLD

MEAS

ENT

1. Select the “CNFG” sub-function, and then press the ENT key.

2. Enabling/disabling the display backlight: press the ▲ or ▼ key to switch display backlight

on (BKLT ON) or off (BKLT OFF). Press the ENT key to confirm your selection.

3. Setting the backlight intensity (appears only If backlight is on): press the ▲ or ▼ key to set

backlight intensity (setting range: minimum 1 to maximum 4). Press the ENT key to confirm

your setting.

4. Selecting the unit of measurement: press the ▲ or ▼ key to select measurement mode:

- “PH SY” = pH measurement with symmetrical input

- “ORP mV SY” = ORP-mV measurement with symmetrical input

- “ORP % SY” = ORP-% measurement with symmetrical input

- Press the ENT key to confirm your selection.

5. Setting the alarm delay time in seconds: press the ▲ or ▼ key to set the alarm delay time

(setting range: 0 to 2000 seconds). Press the ENT key to confirm your setting.

Note: With this parameter you set the delay before the alarm relay activates when

the set point has been exceeded.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 51 52

Comentarios a estos manuales

Sin comentarios

EUTECH INSTRUMENTS alpha-pH 2000D Manual de instrucciones Pagina 35

Comentarios a estos manuales

Relacionado con productos y manuales para Otros dispositivos de entrada EUTECH INSTRUMENTS alpha-pH 2000D