EUTECH INSTRUMENTS ALPHA CON 100 CONDUCTIVITY CONTROLLERTRANSMITTER Manual de instrucciones descargar pdf (Pagina 18)

8.2 Setup mode overview

P1.0: Set Point 1

P1.1: select relay 1 set point value

P1.2: select relay 1 as low or high set point

P1.3: set relay 1 hysteresis value

P2.0: Set Point 2

P2.1: select relay 2 set point value

P2.2: select relay 2 as low or high set point

P2.3: set relay 2 hysteresis value

P3.0: Range

P3.1: select measurement range (with the corresponding cell constant value).

Eight measurement ranges are available.

P4.0: Temperature Data

P4.1: select ATC or MTC

P4.2: select temperature coefficient value

P4.3: select normalization temperature

P5.0: Conductivity Calibration points

P5.1: view conductivity value at which calibration was performed

P6.0 Electrode Properties

P6.1: view cell constant value after calibration

P6.2: view temperature offset value after calibration (only if in ATC mode)

P7.0 Reset to Factory Defaults

P7.1: select YES/NO to confirm reset decision

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Sin comentarios

EUTECH INSTRUMENTS ALPHA CON 100 CONDUCTIVITY CONTROLLERTRANSMITTER Manual de instrucciones Pagina 18