EUTECH INSTRUMENTS ALPHA CON 100 CONDUCTIVITY CONTROLLERTRANSMITTER Manual de instrucciones descargar pdf (Pagina 26)

8.8 Viewing Conductivity/ Temperature Electrode Data – P6.0

Program 6 has two “view only” options that let you check the electrode parameters

for diagnostic purposes.

P6.1: view revised cell constant value of electrode

P6.2: view temperature probe offset (ATC on only)

These parameters will change each time you recalibrate the controller.

P6. 0

elec

P6. 1

P6. 2

t.ofs

0. 0

1000

FCTR

Press ▲and ▼keys together (ESCAPE) at anytime, to leave the Setup mode and

return to Measurement mode.

P6.1: Viewing Conductivity electrode data

1. Key in the password “022” as per procedure in Section 5.

2. Press ▲key until screen displays P6.0 and ELEC. Press ENTER.

3. Screen will scroll P6.1, ‘FCTR’ then cell constant factor. Each time a

calibration is performed, the value of the cell constant factor will be updated.

4. Press ▲and ▼keys together (ESCAPE) to return to P6.0 or press ENTER

to view Temperature electrode data.

P6.2: Viewing Temperature electrode data

5. Follow procedure from above (P6.1) until step 3 and press ENTER.

6. Screen will scroll P6.2, ‘T.OFS’ (Temperature Offset), then amount of offset

(in

C).

7. Press ENTER or press ▲and ▼keys together (ESCAPE) twice, to return to

measurement mode.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32 33 34

Sin comentarios

EUTECH INSTRUMENTS ALPHA CON 100 CONDUCTIVITY CONTROLLERTRANSMITTER Manual de instrucciones Pagina 26