EUTECH INSTRUMENTS ALPHA CON 1000 CONDUCTIVITY CONTROLLERTRANSMITTER (REVISION 3) Manual de instrucciones Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 40
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
36
Appendix 3: External Relays
The relays on the alpha TDS 200 series controller are rated for 6 amps at 110 VAC and
can be wired directly to your final control element (provided its power requirements does
not exceed this). However, to preserve the life of your controller, or if higher power is
needed, it is recommended that you use the controller relay to drive an external relay.
Diagram below shows a typical installation. Wiring should be changed appropriately if
normally closed (N.C.) operation is desired.
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40

Comentarios a estos manuales

Sin comentarios