EUTECH INSTRUMENTS CYBERSCAN CON 1500 CONDUCTIVITY METER Manual de instrucciones descargar pdf (Pagina 12)

Instruction Manual PC 510

• If you are performing one-point calibration, go to step 9.

7. Rinse the electrode with de-ionised water or rinse solution, and

place it in the next pH buffer.

8. Follow steps 5 to 7 for additional calibration points.

9. When calibration is complete, press CAL/MEAS to return to pH

measurement mode.

NOTE

: To exit from pH calibration mode without confirming calibration,

DO NOT press ENTER in step 6. Press CAL/MEAS instead.

If the selected buffer value is not within ±1.0 pH from the measured pH

value: the electrode and buffer icon blink and the ERR annunciator

appears in the lower left corner of the display.

To limit the number of pH buffer values available during calibration,

see section 8.4 Setup P3.2 on page 29.

Figure 7: Next point calibration

for pH 4.01

CAL

READY

4.15

4.01

CAL

READY

4.01

Figure 8: Err message and

electrode icon will appear if

ect

r i

used

CAL

ERR

0.64

1.68

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Sin comentarios

EUTECH INSTRUMENTS CYBERSCAN CON 1500 CONDUCTIVITY METER Manual de instrucciones Pagina 12