EUTECH INSTRUMENTS CYBERSCAN CON 1500 CONDUCTIVITY METER Manual de instrucciones descargar pdf (Pagina 7)

Instruction Manual PC 510

Figure 4: Keypad

ON/OFF

Powers the meter on or off. When meter is switched on, it starts in the mode the meter

was last in when powered off.

SET

Enters advanced setup mode. SETUP mode lets you customise meter preferences and

defaults, and view calibration and probe data.

MODE

Measurement: Press MODE to toggle between pH, mV, conductivity and TDS.

Calibration: In calibration mode, press MODE to access temperature calibration.

HOLD

Freezes the measured reading. To activate, press HOLD while in measurement mode. To

release, press HOLD again.

Note: When auto endpoint feature is switched on, meter automatically holds reading after

5 seconds of stability. The HOLD indicator appears on the display. Press HOLD to release

auto endpoint feature.

CAL/MEAS

Toggles between Calibration and Measurement mode. Example: If you are in pH

measurement mode, press CAL/MEAS to enter pH calibration mode.

Note: Temperature calibration is available from pH, TDS or Conductivity calibration mode.

In Setup mode: Press CAL/MEAS to return to main menu from sub menus. Press

CAL/MEAS again to return to measurement mode from main menu.

ENTER/RANGE

ENTER: Press to confirm values in Calibration mode and to confirm selections in Setup

mode.

RANGE: Press to switch to manual ranging in Conductivity or TDS mode.



Press  in Setup mode to scroll up through su/jointfilesconvert/437882/bgroups. Also lets you increase the values

in the conductivity, TDS and temperature calibration modes.



Press  in Setup mode to scroll down through su/jointfilesconvert/437882/bgroups. Also lets you decrease the

values in the conductivity, TDS and temperature calibration modes.

1 2 3 4 5 6 7 8 9 10 11 12 ... 55 56

Sin comentarios

EUTECH INSTRUMENTS CYBERSCAN CON 1500 CONDUCTIVITY METER Manual de instrucciones Pagina 7