Transmitter Cond/Res 2-Channel M300 15
© 05/07 Mettler-Toledo AG, CH-8606 Greifensee, Switzerland Transmitter Cond/Res 2-Channel M300
Printed in Switzerland 52 121 318
4.1.2 Installation procedure – 1/4DIN models
– Make cutout in panel (see dimensions cutout drawing).
– Be sure surface surrounding cutout is clean, smooth and free of burrs.
– Slide face gasket (supplied with transmitter) around transmitter from the back of the unit.
– Place transmitter into cutout hole. Be sure there are no gaps between the transmitter and
panel surface.
– Place the two mounting brackets on either side of the transmitter as shown
– While holding transmitter fi rmly into the cutout hole, push the mounting brackets toward the
backside of panel
– Once secure, use a screwdriver to tighten the brackets against the panel
– Face gasket will compress between transmitter and panel
CAUTION: Do not over tighten brackets
Comentarios a estos manuales