EUTECH INSTRUMENTS ALPHA COND 500 - REV 4 Especificaciones descargar pdf (Pagina 21)

Transmitter Cond/Res 2-Channel M300 21

Printed in Switzerland 52 121 318

5 Placing transmitter in, or out, of service

5.1 Placing transmitter in service

After connecting the transmitter to power supply circuit, it will be active as soon as the circuit is

powered.

5.2 Placing transmitter out of service

First disconnect the unit from the main power source, then disconnect all remaining electrical

connections. Remove the unit from the wall/panel. Use the installation instruction in this manual

as reference for dis-assembling mounting hardware.

6 Quick Setup

(PATH: Menu/Quick Setup)

Select Quick Setup and press the [ENTER] key. Enter the security code if necessary (see section

9.3)

Note: Refer to section 3.3 for information on menu navigation.

While in Measurement mode press the [MENU] key to bring up the Menu selection. Select Quick

Setup and press the [ENTER] key.

Convention:

line on display => a

line on display => b

line on display => c

line on display => d

Only lines a and b on single channel models or lines a and c on dual channel models can be

conﬁgured in Quick Setup. Go to the Conﬁguration Menu to conﬁgure remaining lines.

6.1 Sensor Type Selection

Select the type of sensor to be used with the M300 transmitter. Choices are ‘Cond(2)’, used for

all 2-Electrode type sensors and ‘Cond (4)’ for all 4-electrode Sensors. Press [ENTER].

Single Channel

NOTE: Dual channel transmitters use the labels ‘A’ and ‘B’ to designate sensor channel

inputs. These labels appear in the data input ﬁelds where conﬁguration of both channels

is possible.

Dual Channel

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 63 64

Sin comentarios

EUTECH INSTRUMENTS ALPHA COND 500 - REV 4 Especificaciones Pagina 21