EUTECH INSTRUMENTS WP PCD 650 Manual de instrucciones descargar pdf (Pagina 64)

Instruction Manual PCD 650

Figure 49 : Conductivity calibration Screen

7. The upper display shows the conductivity reading of the solution with

respect to previous calibration (if any) & lower display shows the

conductivity reading of the solution without any calibration. Use &

keys to adjust the upper display of the conductivity value of your custom

solution.

8. Press ENTER key to confirm the calibration.

9. Press ESC (F4) to go to measurement mode.

10. As for the case of multi point calibration, rinse the probe with de-ionized

water, and repeat step 1 to 7 for every calibration using the desired

calibration solutions until all points have been calibrated.

Function Keys available in Conductivity Calibration mode:

TEMP (F1)

Goes to temperature calibration

CLR-C (F2)

Clears previous calibration (if any) after ENTER key is pressed in

confirmation screen

NEXT (F3)

Shows calibration report

ESC (F4)

Exits from calibration and goes back to conductivity measurement

mode

ENTER

Confirms the calibration

Increases/decreases conductivity cell reading

(Not functional)

3.6.2 Automatic calibration (For Conductivity Calibration)

In the Automatic Calibration mode, the meter is capable of accepting either

single-point or up to 5 points for multi-point calibration with maximum of 1 point

per specific measurement range. Select automatic calibration mode in the

Conductivity Setup screen. See ‘Conductivity Settings – Page 1’ on page 86

for the set up procedure. Press (F2) to start calibration and the meter displays

cell adjustment screen as mentioned in the above section.

Note: If you wish to

completely re-calibrate

the meter, you need to

clear previous

calibration data. Press

CLR-C (F2) key to

clear previous

calibration. The meter

shows you

confirmation screen.

Press ENTER key to

confirm deleting

revious calibration.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 119 120

Comentarios a estos manuales

Sin comentarios

EUTECH INSTRUMENTS WP PCD 650 Manual de instrucciones Pagina 64

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control EUTECH INSTRUMENTS WP PCD 650