EUTECH INSTRUMENTS WP PCD 650 Manual de instrucciones descargar pdf (Pagina 68)

Instruction Manual PCD 650

8. Rinse the probe with de-ionized water. Place it in the next solution and

follow the steps 2 to 7 to calibrate other points, if ‘MULTI’ point calibration

is selected.

9. Press ESC (F4) to go to measurement mode. The meter shows the

resistivity reading of the solution in measurement mode.

3.7.1 Resistivity Calibration Report

Calibration report gives you information on calibration. It includes date &

time on which the last calibration was done and the offset.

To View resistivity Report:

1. From resistivity measurement mode, press left

or right arrow key to

navigate to other available functions until you see REPO function in the

LCD

2. Press REPO (F2) key. The calibration report is shown in the display [Figure

53].

3. Press PRIN (F2) to transfer the calibration report to the computer.( Refer

page 37 to print data)

Figure 53 : Resistivity report screen

Note: The function of the keys available on the resistivity cell

constant/calibration/ report screen is same as previously described in

conductivity calibration.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 119 120

Sin comentarios

EUTECH INSTRUMENTS WP PCD 650 Manual de instrucciones Pagina 68