
Instruction Manual PCD 650
78
4.2.3 System Settings – Page 3
Figure 70 : System Settings - Page 3
This page allows you to set auto-off and back light related parameters.
Parameter Description Factory Default
Auto OFF
ENABLE – Turns off the meter automatically if no key is
pressed for the time period specified in ‘ON TIME’ below.
DISABLE – Does not turns off the meter automatically
ENABLE
ON Time
After the last key is pressed, no. of minutes the meter
should wait before automatically shuts down the meter.
Maximum range: 30 min
(This parameter has not editable if ‘AUTO OFF’ parameter
is disabled)
10 min
Back Light
(permanently
ON)
ENABLE – Sets the back light always on.
DISABLE – Sets the backlight always off.
DISABLE
Back Light
ON with
(Key press)
ENABLE – The back light of the LCD is automatically on
when any key is pressed.
DISABLE – Does not turn on the back light automatically.
DISABLE
ON time with
(Key press)
Sets the meter to wait for specified number of minutes
before automatically turning off the back light after the last
key is pressed.
(This parameter is not editable when ‘BACK LIGHT (Key
press)’ is disabled)
(This parameter has no effect if ‘BACK LIGHT (Always)’
parameter is set to ON)
1 min
Note: The above settings may not work if the system time has not been
set as described in page 77.
Comentarios a estos manuales